Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by selvakumar.m

  1. S

    what is called dxf files,how to work with dxf?

    what files can i import by autocad files into pcb editor?
  2. S

    what is called dxf files,how to work with dxf?

    what is called dxf files,how to work with dxf?
  3. S

    what is called as dxf files and how to use it

    how to use DXF files in allegro16.3 .i didn't know about dxf file.what it is and how to use.pls explain me
  4. S

    importing gerber file into board file

    can i edit the imported gerber file in allegro16.2
  5. S

    how to identify that those nets should be in same length

    how to identify that those nets should be in same length?. i dont know how to analyse the length matching information in datasheet.where the length matching information will be given in the datasheet for particlar ic?. for eg: AT91SAM9261B-CU-ND
  6. S

    how should check EMI in allegro 16.2

    I am newly moving to high speed design.so,After routing, how should i check EMI,EMC,SI(signal integrity),and length matching in allegro 16.2 ? please say individual answers for each
  7. S

    what are factor need for to design high speed design board??

    what should be learn for moving to high speed design boards in allegro
  8. S

    how to bring back the deleted text

    how to bring back the deleted text (pin numbers) after created the foot print. iam using allegro16.2
  9. S

    length matching in allegro16.2

    ok.thank u.i get it.can u say what is the main reason for going from 2layer to 4 layer boards
  10. S

    length matching in allegro16.2

    how to check the length mathching in allegro 16.2
  11. S

    importing gerber file into board file

    how can i import the old gerber file into new board layout in allegro 16.2
  12. S

    diff between 2layer and 4layer

    what is difference between 2 layer and 4 layer pcb?. what is important point to handle for 4 layer pcb in allegro 16.2
  13. S

    layout cross section for 4layer

    ok thank u.Is there any way for automatic placement for components
  14. S

    layout cross section for 4layer

    iam going to use allegro16.2
  15. S

    layout cross section for 4layer

    hai,iam new bee to join with u.can u say how to set the 4 layer layout cross section
See more

Part and Inventory Search

Back
Top