Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
HI
you can debug with a small hardware(max232) . loock in help
--in circuit debugger
--hardware setup
that is all .it is too simple to make this hardware
icd2 4550
HI manuel 1139
The same prob:
Connecting to MPLAB ICD 2
ICDWarn0059: About to re-program ICD2 USB Boot firmware code. Please do NOT disconnect the ICD2 or interrupt this operation!
...Connected
ICD0082: Failed MPLAB ICD 2 operation
MPLAB ICD 2 Ready
Thank you for your help
HI
It is ok now
for 24Mhz config oscillator selection is :[divided by 6(24mhz input)]
Thank you
Added after 8 minutes:
HI
It is ok now
for 24Mhz config oscillator selection is :[divided by 6(24mhz input)]
Thank you
HI
Help....when i connect the icd2 to the usb port ,windows says: windows does not reconize it
please i need any advice ...........
Thank you in advance
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.