Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
THanks for your advice.
I'm afraid that most of those OPAMP don't exhibit the right bandwidth at gain 10 (20 dB). A few of them do, that's true. However, the noise figure is pretty high. That's why I was looking on the MMIC side. Maybe hopeless on that side ?
Cheers,
Julien
Hi everybody,
I'm Julien, I'm a nuclear physicist who has to amplify rare pulses (say 1kHz typical repetition rate). The pulse amplitude (50 ohms adapted) vary from 10 to 200 mV and I need to put 20 dB amplification on those pulses. The pulses are negative and exhibit a 1.5 ns rise time and 3 ns...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
