Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
thnx all for the help!
I will try it RealAEL's way. I was concerned that ADS would treat vias different from conductors (vias allow only vertical currents maybe?)
Sorry, but could you elaborate more?
I have one horizontal conductor with a cross section that lies in different dielectrics. I cannot draw define a conductor as such in the ADS.
I am modeling transmission lines on ADS. Conductors in the technology I am using (CMOS) intrude into two or more dielectric layers similar to the sketch below. ADS 2011.01 does not allow conductor thickness to be equal to or larger than layer thickness. Does anyone know some workaround?
I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.