Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
HI,
I decided to send it as tcp/ip packets.I don't for that which command i have to use?I am connecting one modem to one pc then other to second pc,in each modem i inserted Tatadocomo sim which is gprs activated.This is the commands that i have used in the sender side:
SENDER
at
ok...
That i tried.But i had a problem with the at command below
AT+ZIPSETUP=<N>,<IP>,<M>
1) IP means the address of the module or destination?
2) How can I get the port no (M)?
Hi,
I want to configure gprs modem to transmit data from ARM to a PC's hyper terminal.Is it needs to configure the tcp connectivity of the modem?I am totally confused with this problem.I don't know how to configure the modem to send a data from ARM to a PC's hyper terminal.If anyone...
hai,
I want to send a data using gprs modem.for that i am supposed to use the command AT+ZIPSETUP=<N>,<IP>,<M>.How can i get the port no(M).please help me..............................
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
