Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by satyasiva

  1. S

    basics of LDO - request for resources

    basics of LDO Hi, I want to start LDO design. Could you provide documents for that.
  2. S

    waveform window question

    This is not possible in spectre
  3. S

    why capacitive loads are drived by OTA?

    to drive a capacitor, if we have a constant current source. that is good. ota acts constant current source., i.e, it's o/p i s current instead of voltage.
  4. S

    why do we use poly as gate?

    why do we use poly as gate?
  5. S

    Suggest me some books about Analog Design

    Analog Design Just read one book. read and work simulataneously
  6. S

    why do we use poly to connect poly

    why do we use poly to connect poly
  7. S

    Why the ppen loop gain of an opamp is expressed by this equation?

    Open Loop Gain because the gain depends onfrequency
  8. S

    Why do we use replica bias ?

    replica-biased circuit Replica bias is used as bias for delayelements for VCO. It provide good stability over PVT such that freq. will not vary over PVT.
  9. S

    why oscillator o/p is sinusoidal?

    this is ok for lc type oscillators. But what about ring oscillators.
  10. S

    Simple RC circuit interview questions

    simple hpf circuit I f it is LPF, o/p levels will change fromQ1 to Q3.
  11. S

    why oscillator o/p is sinusoidal?

    why oscillator o/p is sinusoidal or squarewave? for a simple RC circuit the o/p is not a sinusoidal. Then for a VCo how we r getting sinusoidal o/p
  12. S

    how to model PLL using MATLAB?

    pll matlab example hspice is similar to spectre. for noise simulation we need hspiceRF or spectreRF.
  13. S

    how to model PLL using MATLAB?

    pll model matlab Is simulink also part of matlab?
  14. S

    RMS jitter specification

    I have rms jitter specification for a pll. what actually this refers to? Is this random jitter? If we do the phase noise simulation and calculate jitter value, what jitter we get?
  15. S

    how to model PLL using MATLAB?

    pll matlab can any one suggest any papers how to model PLL in MATLAB?
See more

Part and Inventory Search

Back
Top