Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I am using MPLAB v8.84.
I had made PORT A as input port in my program. I want to give input to that port but if i edit value in make it is not changing.
Then i created a workspace in debugger and created a instruction to set A0 bit high. While the simulation is running i fired the instruction by...
I am using MPLAB v8.84. I had created a new workbook and made an instruction to set high portA, 0 bit.
But the portA value is not changing in Make window.
- - - Updated - - -
I am using MPLAB v8.84. I had created a new workbook and made an instruction to set high portA, 0 bit.
But the portA...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.