Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello,
I have several question regarding HZ.
1. What does it means exatly when we say a pad is HZ? (in term of voltage current)
2- Could we directly connect two HZ pads without any specific care?
3- What if we connect a HZ pad with low or high level pad?
Thanks for your help
Re: LNA measurement
Hello Kspala,
As you noticed, it is -80dBm and not 80dBm (typo error)...sorry for the inconvenience. Moreover, I confirm you that on the VNA, I use, the level of the power source can only be decreased down to -20dBm.
Your help is appreciated. Thanks
Samy
LNA measurement
Hi Experts,
I need to measure the input impedance of a LNA designed to amplify RF signals around 80dBm. However, the source of my VNA can only be decreased down to -20dBm. .....Any idea of how I can do this measurement?
Thanks,
Samy
Re: Ground loop in RF
Hi Flatulent,
Thanks for your help.
You stated in your previous post: "No full circle routs with part of the signal path going left to right and then making a U turn to come back to the left."
What could be the effects to proceed like this? (Noise coupling?)
Thanks,
Samy
Ground loop in RF
Hi,
I need some information ( Application notes, book reference, article) about ground lopp and how to minimize then in RF domain.
Thanks,
Samy
Hello,
I am newbie in the field of....... I want to learn how to derive the equations that rule the design of LC balun. I found this equation in several papers, but was not able to derive them from the circuit topology.
I hope someone could help to this.
Thanks,
Samy
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.