Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I'm looking for a Freelance PCB designer to help me with BGA routing. I'm using Altium Designer & I'm trying to outsource the BGA routing part of my project. Please send me an email for more details srav.mic@gmail.com. I'm trying to get this job done ASAP.
Thank you.
Hi everyone, I'm working on a hobby project & I have a schematic design which was captured using EAGLE. I'm trying to redraw it but I am stumbling with some schematic symbols. Please review the attached file and help me with the schematic symbols.
Thank you in Advance.
Hi everyone,
I am working on my first PCB design project using Altium Designer and I'm confused with polygon pours. Can someone help me with these questions.
*Why do we need a polygon pour on PCB's ? Is Polygon pour required for every signal layer ?
*
Hi everyone,
I am working on a simple 2-layer PCB design. Almost done with it but I'm not sure How to use ground and power planes in a 2-layer board. The design consists of an op amp(MCP619-I/ST) with a few resistors. Both top and bottom layers are used for routing.
Please review the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.