Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi expert,
I have just installed tensorflow 1.5.0 with pyton 3.6 version in conda environment and using Jupyter notebook as the code editor.
I want to make sure the tensorflow installation was successfully installed, so I tested it with
then it return the following information that I don't have...
Hi Expert,
We have a problem with laser cutting machine (LC1325M), it cannot cut through the metal sheet.
How to figure out the problem?
thanks in advance.
Regards,
Sona SS
Hi Expert,
The following shearing machine having a problem with the measurement of its stopper position.
When we want to cut a metal plat, we usually set the stopper position to where the plat will be cut for a particular length. For example if we want to cut a 300mm metal plat, we set the...
Hi,
I have a 3 phase 380V of AC breaker motor part need to be standalone test to make sure this part is still good.
How to standalone test of this AC breaker motor part, is it using insulation check or just resistance check? and what is the good measurement range?
Thanks in advance.
Hi,
Since I couldn't find the datasheet of CW508 or CW509 or GM812C518 IC, anyone here can suggest me for the substitute of this pulse igniter IC?
Thanks in advance.
Hi fiolin!
The modem was taken care by the customer service, I don't know exactly what they were doing to my modem. But they said, there is something wrong with the modem.
ups I forgot to close this thread, thanks to you nikhilele, you helped me. here I post the code
// LCD module connections
sbit LCD_RS at PORTD6_bit;
sbit LCD_EN at PORTD7_bit;
sbit LCD_D4 at PORTD2_bit;
sbit LCD_D5 at PORTD3_bit;
sbit LCD_D6 at PORTD4_bit;
sbit LCD_D7 at PORTD5_bit;
sbit...
Hi!
I'm trying to get ONLY "+628987654321" (without quotes) from sequence string below
+CMGR: "REC UNREAD","+628987654321",,"11/07/10,18:25:40+28"
I tried code below
// LCD module connections
sbit LCD_RS at PORTD6_bit;
sbit LCD_EN at PORTD7_bit;
sbit LCD_D4 at PORTD2_bit;
sbit LCD_D5 at...
Hi!
I tried the sequence of AT-commands to connect to GPRS (you can see on https://www.edaboard.com/threads/217319/)
AT+CGATT=1
OK
AT+CGDCONT=1,"IP","INTERNET";+CGDCONT=1,"IP","3gprs"
OK
AT+WIPCFG=1 //START IP STACK
OK
AT+WIPBR=1,6 // OPEN GPRS BEARER
OK
AT+WIPBR=2,6,11,"3gprs" //SET APN...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.