Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thank you BradtheRad, i will try to change C10 tommorow.
Edit: I tried different values of C10, it didnt help... And without C10 its oscilating even without load.
Hello Everyone,
I curently working on adjustable constant current source with LT3741. Design specifications are:
Input voltage: 10 V - 15 V (lead battery)
Output current: 0 A - 3,3 A
Maximum output voltage: 5 V
Switching frequency: 200 kHz
Schematic:
**broken link removed**
Parts were chosen...
I'm using these diodes https://hvstuff.com/10ma-20kv-high-voltage-diode-hv-rectifier-tesla-ham
Those should have Maximum Reverse Recovery Time 150 ns, so I think it should be Ok, but I'll have better diodes(higher voltage and current rating) and caps soon.
Yes, I measured it directly across...
Hello Everyone,
Project I currently working is about a power supply for powering X-Ray tube. I would like to get more information about this topic and some help from you guys, if you are so kind. I apologize for my bad English.
So, my goal is to build a power supply with max. output voltage...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
