Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
HELLO everyone,
I am trying to write and read into a Micron Flash Mem MT29F16B... using MSP430F2419 uC. initially i woudl like to write only 1 byte to the flash mem on a 400khz clock source...
i am following the routines given in the datasheet for cmd, addr, and data...
Hello All,
I want to design a circuit where I want both +ve and -ve supply voltages. However, I do not want to use dual supply. Is there any circuit or chip that produces a dual polarity output with single polarity input.
I actually found one.
MURATA POWER SOLUTIONS - NDTD1212C
Is...
clamping circuit
hi all,
I want to design a clamping sort of circuit which would produce an output of 0V when the i/p to it is +5V and 5V when the input to it is 0V... the input is not a pure sine wave... its a sine-wavish pattern with a frequency of around 50-60hz...
can someone please...
Hello All,
I am designing an amplifier for a signal of magnitude 200-500 mV.The signal is more or less of a noise pattern which deviates its output even after application of simple appliances like AC, microwave, tube-lights, etc... Hence, designing an amplifier for the same is...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.