Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
thanks for your attention
It use in Plasma technology
They use a 10-70 kHz power supply with Voltage range 20KV-30KV
But If use 13.56 Mhz frequency, the output voltage can be at range 1-2 KV
the load is 50 Ohm
I need a 2KV peak to peak Voltage at 13.56 frequency
- - - Updated - - -
It use...
hi I need to make a 13.56Mhz power supply with about 1000 V - 2000 V output voltage
I used a crystal and produced 2 Vp-p but low current
and consider to use
https://www.st.com/web/en/catalog/tools/PF189027
for power amplifying
Problem:
but now I need a pre-Amplifier to amplify my first...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.