Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
i am using matlab 6.1 .... in my project i need to send data through parallel port of my comp .... i am using following command to access parallel port but getting error ....
PLZ HELP ME
cmd :-
parport=digitalio(’parallel’,'LPT1′);
error :-
??? Error using ==> digitalio/digitalio
Error...
Actullay I have got STK502 starter kit (extension for LCD AVR ) . I don't have STK500 board . The kit has a ATMEGA 169 microcontroller . Can I programm it with this kit .
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.