Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Can anybody help me,
I would like to learn the tool Flotherm by Flomerics.
I couldn't find out any demo or evaluation tool in Mentor Graphics website.
so, what is the best way to learn the basics, without buying a licensed one.
Thanks,
rinj.
Re: gerber to orcad layout
Dear all,
Please help me.
I have the GERBTOOL in orcad10.5.
I want to do a reverse engineering task. I have gerber data (top, bot,drldwg, smt,ssb)of a 2 layer board. There is no other data like max file,schematic or netlist available.
I want to create the max file...
pcb standard
Sakthivel,
Some orgn in Bangalore is conducting CID certification I heard. The apprx cost is Rs.30,000/
I too was in search of that for the past 2 years.
from designers comment, some says it is not worth. bcz no companys are looking for CID certified designers in their profile...
Dear all,
this question is to experienced power electronics circuit designers.
I have to design a PCB layout for 115ac to +28/+15/+5vdc .
The circuit contains,
1. Fuse and Inrush current protection ckt
2. EMI Filter
3. LC filter
4. Bridge rectifier and DC capacitor
5. Flyback transformer
6...
pcad to allegro
Dear all,
One of our company bussiness unit have the following.
"The existing schematic databases are in PCAD and the pcb databases are in Pads PCB."
they want me to do a redesign.
But I have the design tool, orcad schematic and layout plus and Allegro tools.
Is there any way...
mentor graphics to allegro
“we've found Cadence to be a very arrogant company in the past 5 years.”
It's true. "
I too feel the same.
I am a cadence costumer for the past 3 years, and a member of cadence users & forum. None of the tech support contacted me all these days and not received any...
orcad copper pour isolation
In OrCAD 10.5 to disable thermal isolation for individual pads and for the copper pour as a whole, select the vias from the spreadshet, go to prpperties/edit padstack, enable the option Flood planes/pours.
regards,
rinj
hi all,
I too have the same question. and I have seen this in the standards like IPC.
How Can I determine the elevation while designing a board, if the pcb is used internationally?
hope for a clear reply
thanks,
rinj
how to build a pad layout
hock,
in a MAX file in layout plus,
go to padstack spread sheet, select the via (via1/via2/via3...), edit the properties eg: drill size
In the lib manager while creating a footprint,
select the pin, go to padstack spread sheet, ( the selected pin will be highlighted...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
