Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi barry,
that's what I did :)
I was only confused because the device is also in the list of devices supported by Lattice Diamonds.
We have now decided to use another device.
THanks!
I usually design ECPs with Lattice Diamond.
Now I have a very small project with a CPLD from the ispMACH 4000V series and wonder how I can synthesise the code for it.
On the Lattice website ispLever Classic is mentioned, for which you have to buy a licence for 600$.
However, I also found the...
Dear community,
Lattice Diamond automatically reanalyses the hole design after each IPCore change. This takes a lot of time.
Since I have a number of ipcores to update, I would like to know if there is any way to turn this off, so that I can only start the analysis at the end of all changes...
Dear community,
I want to update all ipcores of a design.
Since it is very tedious to update every single ipx file in Lattice Diamond (there are many in this design) by hand, I would like to know if there is a tool or a Tcl script for this?
Thnx
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.