Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi everybody,
I want to type some characters in PC then transfer them to LPC1768 with Ethernet(Network) and LPC 1768 show these characters in TFT LCD. I used from some codes in Keil website. I put TFT LCD library instead of GLCD library in codes. I could turn on TFT LCD but after initial...
please do following steps:
step1: check your configuration panel (right of GUI) for margins.
step2: see your .gsr file and check your VDD and GND values.
step3: see your .lef , .def files and check your VDD and GND connections.
Question about Redhawk software
Hi
I installed Redhawk software, when i want to import .gsr file in it, i face with an error.
the error message : fail to read gsr file
I changed path and directory of gsr file but it was not useful.
please help me.
thank you.
Hi everybody,
By using 2014a matlab Simulink, I designed a voltage to time converter as a sub-system but an error which you can see in attachments occurred; then I changed my design but again I faced many errors, how can I change my design?
I'm looking forward your answer!
Thank you very much!
Dear BradtheRad,d123
It is a challenge that i use just two 7805 regulators. I must not use other components.
so circuits that have not two 7805 regulators are useless for me.
Hi everybody,
I know that we can make positive voltage with 7805 and negative voltage with 7905.
I want to make positive and negative voltage at the same time with just two 7805 regulators.
can you suggest a circuit for it?
I'm looking forward your answer!
Thank you very much!
Dear dick_freebird
I added R(load)=50 ohms in parallel with C(load) and my measurement for quiescent current was near to 20mA that is unacceptable,value of it must be lower than 5uA. when i changed R(load) to higher value for example R(load)=2k , i got better result. what do you think about it...
Hi everybody,
I am working on Digital LDO simulation with Hspice software. I can not measure quiescent current in no load condition. I want to know that I must turn on or turn off all of the switches or they must be in the normal mode?
how can i increase I(load) and show I(load) dependence of...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
