Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
i would like to simulate the elecronic ballast circuit which shown below using simulink.There is an input buck boost powerfactor correction stage in the input and a resonant inverter stage is in the output stage which is used to drive the lamp.i would like to operate the buck boost convetrer in...
i would like to deign an electonic ballast for flourescent lamps.i would like to include a buck boost power factor correction circuit for the improvement of powerfactor. a series resonant parallel loaded circuit is used to drive the lamp output stage.i would like to switch the circuit using zero...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.