Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi
I am drawing the layout of my circuit using Virtuoso. I am using create path command to connect different blocks.
By mistake I pressed some key. Now, when I draw a path it shows the DRC rules ( like minimum metal width, minimum spacing) which makes the layout drawing easier.
I tried to...
Hi
When I plot the montecarlo simulation result using scatter plot three parameter are shown on the figure (r, m and b)
Can anyone tell me what are these parameters? ( I have attaced the scatter plot results)
Thanks for your help :)
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.