Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
What do you mean by code hooks? can you give examples or links that explains this fully?
So what you say is that there is no way to detect in code if I selected Debugger -> Select Tool -> PICkit 3 or Programmmer -> Select Programmer -> PICkit 3 and I need to use the Debug/Release configuration...
Hi,
I am using MPLAB version 8.86, PIC18F452, XC8 compiler and PICkit 3 Debugger/Programmer and have the following questions -
1) What is the difference between Debug and Release when I compile ?
2) I need to protect Block 0 code so I use CP0 in configuration to ON (#pragma config CP0 = ON)...
@keith1200rs
After more than 30 years in this field I will take your words for granted :)
PCB-POOL.COM link is really helpfull...
If I will summarize the general solder mask/resist process -
1) at start the soldermask process is applied to the whole PCB (even to the pads)
2) it is harden using...
Thanks for you feedback.
Actually there is SMOBC: **broken link removed** (I didn't create this value) and in lots referenes in google.
I think it is called historically SMOBC and probably in those days it covers only the bare copper but over time it is just called solder mask and cover the...
Hi,
I do know what is SMOBC which is a polymer over the copper traces to protect them, prevent bridges in wave solder process and provide better look to the PCB board.
What I do not understand is that I see this solder mask layer applied to the rest of the PCB. if it is applied to the rest of...
Hi,
I am looking for a datasheet/AN/layout or any other relevant technical document for Marvell ARMADA processor.
Processor model can be any, but ARMADA 600 specifically will be very good.
More info: **broken link removed**
Thanks in advance.
I am planning a board which has upto 20 IC(Through hole) as a prototype on a wire-wrap board.
will use wire-wrap wires and my question is related to the power distribution network; since I am not using PCB and thus power/gnd planes not relevant, so will use power/gnd bus, how it is recommend to...
icd3 diy
ICD3 will be available from v8.15 of MPLAB IDE.
MPLAB ICD 3 In-Circuit Debugger System is Microchip's most cost effective high-speed hardware debugger/programmer for Microchip Flash Digital Signal Controller (DSC) and microcontroller (MCU) devices. It debugs and programs PIC® Flash...
C# or VB
VB.NET and C# are based on .NET platform and both of them are producing managed code; Programs you write with this technology will require MS Framework to be installed on the target machine.
I used VB.NET with my project to create the GUI and it was enjoyable and rather easy.
Now I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
