Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
emule for books
I think this forum has the huge collection of book links. Just go to the the section "EDA & Electronics Related E-Book links". Enjoy!!!
THe Vpp means voltage peak to peak. If input range is 1 V peak to peak then you can either use the voltage from 0 to 1 V or also from -.5V to +5V..
Added after 18 seconds:
THe Vpp means voltage peak to peak. If input range is 1 V peak to peak then you can either use the voltage from 0 to 1 V...
It is not necessary to know about the internal ckt to analyze the op-amp containing circuits. But you should know the different modes of operation of opamps.
any rf expert here
You can modulate the signal using IF if your superhet is used only for a single carrier. But it will be a problem if there are more than 1 carriers. In that case, you would need frequency converter to downconvert the RF carrier to IF.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
