Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thanks for the reply. Are you saying that rate of change of phase v/s frequency depends on length too other than width and height of substrate? The individual phases at output will be different ,true, but phase difference should be constant right?
Hello Everyone,
I am doing a project which involves Butler Matrix feed. As i was designing the feed i encountered that the slope at which the phase v/s frequency plot changes varied with ports. As such the phase difference between ports was not remaining constant wrt frequency. When i tried...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
