Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by rampo

  1. R

    Protel 99SE Print Problem

    Click on the properties of printout and remove all layer, then add only top layer and multilayer to print the top side or bottom layer and multilayer if you want print the bottom layer. I have the same problem if i don't remove top overlay layer. Good luck!
  2. R

    need 12V ~ 10A power supply

    12v power supply 10a Loot at www.st.com and search "L4970". I use its to create a very good switching power supply up to 10A
  3. R

    Need Help with disco lights

    triac disco light You can connect the port I/O by optodiac to the triac.
  4. R

    AVR Complier For ATmega128

    I have some problems with code vision, becase if i enable the external memory by wizard tool, esternal memory don't work!!! Bye
  5. R

    AVR Code Vision or IAR ????

    What's the better C compiler for AVR Code Vision or IAR??? Thanks
  6. R

    any expert on GSM modems?

    Any one tell me why can i buy the less expensive GSM modem to plug-in on my board? Thanks
  7. R

    49 Mhz Xtal TX and RX

    tx 49mhz I'm looking a very simple schematics about TX and RX circuits for 49 Mhz. This circuits must have a crystal to lock the transmission frequency and lock the reciever. Thanks a lot! :D
See more

Part and Inventory Search

Back
Top