Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
re: lcd display problem
Check whether you are using busy flag method or enable strobe method for LCD programming. I think busy flag is most widely used and effective method.
Kindly help me,i am getting error of usbaburnersp not found in Avrdude and Extreme avr burner. my dell win7 laptop is detecting usbasp and I have installed many drivers for it. But have no success.
Hi,
Dear All,
After fighting with USBASP after 5 days I switched over to parallel port programmer using Win AVR & Avrdude which has given me result in just one hour. It is very simple to construct. Pin nos 18-25 are GND. & 7 to 10 are Reset-SCK-MOSI-MISO serially.
Thanx to all.
I am using updated firmware & software also. I updated my windows driver for XP & Windows 7(which I am using).
It also gives chip enable error for 89S52.
Kindly, suggest any solution.
Dear All,
please help me I am getting error of "programmer can not be found". I am using usbasp for 89S52 with fuse & lock bits EF for low & c9 for hi. before some time i got error of "no chip enable". Voltage level of usb programmer is near about 5 V & 89S52`s 4 to 4.5V
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
