Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi ,
I am not getting the address/register details to set the pin 6 as active low. Could you please send the details if you found it.
Thank you in advance.
Hi all,
FT234XD is one USB to UART chip from FTDI, it requires some FW to flash into the same device.
It configures GPIO pin 6, and I need to define this pin as Active low output. I am not finding code for this. Please tell me where i can find the code? or send me the code if u have.
Thank you...
Hi all,
I never used interrupt function before and want to use interrupt for usart receiver i.e I just for to glow an LED or set a flag whenever a byte or string is recieved. Help me in writing the code for this.
Thanks in advance.
Hi everyone,
Can anyone tell me how to test whether debugger is working fine or not?.
I am using XDS100 v3 debugger. When i try to debug my arm controller using CCS IDE it is giving Debugging failed error.
I want to confirm whether debugger or controller has gone bad??.
Thank you in advance.
Hi all,
Has anybody used kxtf9-4100 tri-axis accelerometer??. I need its I2C address and registers.
It would be better if you have any i2c code for it also.
Thank you in advance.
Hello everyone,
I want to generate a sine wave signal from AMC7812 DAC 24bit device. I am giving inputs to dac through spi code. To wake this device up "6B 7F FE" code must be sent and further data serially. I am able to write only one time to 24 bit register of DAC. That is device is up when...
I agree that current flows via lower resistor path. But When it comes to high speed signal does it follow the same.???
Because what I think is reactance is directly proportional to either frequency or inductance , when frequency is high then reactance is high and so inductance will be low.
Is...
Hello everyone,
I am very new to RTOS. I have basic knowledge about embedded programming. And I am given a task that i should use the SYS BIOS RTOS to run a simple example ( say LED BLINK) on msp430f5438 evm board. I am using CCS IDE for that. I have no idea how to start with.
Can anybody help...
Hello,
Thank you all for helping. Now we are able to get 27mV offset for 0x00 input code. We changed the 10k pot to 100k pot. Before it was 250mV for 10k pot at zero scale error.
Hi all,
I am very new to RTOS.I am using CCS IDE. Trying to build RTOS (TI SYS BIOS) for msp430f54378A evm board. Can any one tell how to use RTOS for a simple program. Please provide any link or any example to understand this.
Thank you in advance :smile:
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
