Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I have the same problem. the DRC rules are store in a file named: "calibreDRC.rul" in the folder: ncsu_basekit/techfile/calibre. The error message is "Failed to find DRC rules divaDRC.rul". I am wondered if the problem comes from the design kit?
Please feel free if there is any idea or...
Dear all.
Thanks.
S-param simulation phase is passed true, but the problem is that in Harmonic Balance, which i deside to find nonlinearities, only the first harmonic will appeared and no 2nd or 3rd harmonics will be available.
I think the problem may be with the model I used. Beacause, some...
Dear all,
Hi.
I simulate a MMIC RF power amplifier (PA) in ads (advanced design system), s-param simulation is working well but harmonic balance not. Increasing the input signal power of the PA, the output signal power increases unconditionaly, even more then DC power dissipation. 3rd order...
Hi, me too :(
---------- Post added at 19:08 ---------- Previous post was at 18:09 ----------
I find this site very helpfull, it uses GPDK090, **broken link removed**
Good Luck.
Dear all,
Hi.
I have a same error problem with my design, the error is: " 'M1' is an instance of an undefined model 'nch' ."
If any one know the solution, it will be appreciated noticing me. Tnks.
hi all,:D
I want to know how can I run Hspice Simulation from matlab?
Please note that I said Simulation not Hspice itself only,
this means I can run Hspice from Matlab but I don`t know how to run it`s simulation then for generation x.lis output from x.sp input.:?:
Thanks for every.
Added...
Is there any program most powerfuller than Orcad!?
I think the answer is NO.
but for simulating digital components like microcontrollers "Proteuse" is one of the best.
You know?
atmega128
I`m going to use atmega 128 to connect to a mmc,
i have some problems:
1)voltag droping when placing mmc in the board,
2)after some duration of programing my micro program never works properly.
Note: I program 128 with TNM programer by the RXT and RXD way.
Any sugestion?
Added...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
