Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: stepper motor driver help
i am trying to control the l297 with help of pc parallel port how should i give the clock pin can i just generate the pulse and wat abt t home and sync pins
hi,
I want to control a bipolar stepper motor(4 wires)using pc parallel port.i am using pm 42l-sye8 motor.its specification are 24v,600ma,coil Resistance 7ohm,the driver mentioned in the datasheet is udn 2916bv but i thought of using l293d,can i proceed with l293d or should i go for udn...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
