Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi. im using PIC16F877a to make a line following robot.
im programming using C language.
it run with no problem when i simulate it using Proteus.
the problem is, when i flash it into PIC, nothing happen.
the PIC is like not responding when there is input.
for example, when i give input '1' to...
Hi. I'm doing a line following robot.
my problem is, in the simulation (pic as below), the code seems like does not work at all.
here is my code
based on my code, when port RD0 or RDO+RD1 or RD0+RD1+RD2, the motor in out1, will run backward and the motor in out3 will run foward, thus the...
actually i want to include it. but, my proteus/ares's component library don't have resistor in it.
so, i'll just remove it from the pcb layout and just manually drill on the pcb later and use the jumper cable.
Hi. I'm using the software Proteus for simulation. After designing the circuit, i want to convert it into PCB and using the software Ares.
But, when i'm using Ares, i cant find the component resistor in my PCB design. It is weird as all of other component is found.
Here's some pictures:
This is...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
