Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I am working Currently on project that require me to do the following
1)obtain the histogram of an image X 2)play on that histogram and obtain a new one lets say Y
My problem is how can i apply this new histogram to the original image
I'm using the function histeq(I,Map) but my Advisor want...
it's ok i'am allowed to use as many as possible of opamp there is no limit for that but i still did not get how to calculate the components values could u explain more for me
I want to design a simple sinewave generator that give me a sinewave with 10kHZ frequency and at least 3V Peak to Peal i have many circuits and i try to simulate but i still cant get the most accurate one right now i found this circuit
**broken link removed**
but i dont know how to chose the...
yes my power is low , could u please give me the schematic to the circuit that you have mentioned in your post and how am gonna to use it with frequency synthesizer
I am working on a project right now that require for me to use a frequency synthesizer as a carrier frequency generator see the picture below plz
my problem is i cant find a circuit that can take two input which are the carrier frequency generated by the synthesizer and the message signal...
thanks alot zorro that was very helpful u helped me so much :)[COLOR="Silver"]
---------- Post added at 06:55 ---------- Previous post was at 06:50 ----------
i have one question why u choose m to be equal = 99
this is the code but i think something wrong on it can u check plz
m=99;
fd=100;
n=0;
n=n+1;
ts=1e-4;
fs=1e4;
for i=1:100
b=abs((n-(m/2))*1e-4);
c=(100/(pi*b))^(1/4);
f=(2*pi*fd*b);
d=besselj(1/4,f);
h_n(i)=gamma(3/4)*c*d;
n=n+1;
end
%normalization of the windowed impulse resoinse
n=0;
k=0...
i want to design a digital filter to in matlab with the given impulse response attached to filter a complex guassian process of length 100
i dont know how am gonna to do it and i dont know how can i determine the order of the filter below attached the impulse response formula
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
