Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
HI,
Go to XSection option.just click on that.By default only Top and Bottom is there.Right click on first coloumn, you get option add layer above,blow or remove.Using this you can create required number of layers and rename it.
Hi Prince,
For changing only name you can use edit->text,make sure that class package geometry subclass pin number should be enabled,just click on pins,then you can edit.If we removed this text it becomes mechanical pin.If u want to convert it to connected pin again place connected pins.I...
hi,
Open that .dra file.Then go to tools->padstack->Modify padstack,right click on it.Edit option comes. then save as by giving proper name.Then again go to tools->Padstack->replace here you select old padstack and below select newpadstack.Then give pin no which you want to replace
Before you importing in to boardfile set correct library path,Setup ->User preference->Paths->Library ,select path for both pad and psm paths.Then draw outline and import into board file.Then Place->Quick place.If no errors or warnings all components will come inside.
If you deleted text it becomes mechanical pin.Then again you place pins as connect pins.If you want to change pin number,you edit it make sure that by enabling class package geometry subclass pin number.
Click on i symbol(Make sure that only net is enabled in Find) and then select specific net.The total length is displayed.Otherwise go to Tools->quick reports then select etch length by layer report.Here you get all signal length report.By comparing this you can check the length match of signals.
Hi,
Go to Xsection.There are only two layers by default.Then right click on number coloumn below top layer.The option "Add layer below", "Add layer above" and "Remove layer" option comes.You can add any number of layers using first two options.The .jpj image file is attached for your reference
Two layer means only top and bottom layers present.Components can be placed on both top and bottom.Routing of signals and power only can be done using both layers.In 4 layers top,ground,Power and bottom present.Components can be placed both top and bottom and routing of signals can be done on...
You import the schematics.Then only connection rats are enabled and components can be placed.After importing give quick place then components automatically comes in to board file
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
