Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hello,
Few days back i have purchased (STM32 STM32F103VET6 development Board+2.4) from ebay.com.
I'm now trying to flash this board but I dont know where to start. I have also received a cd which contains some datasheets and some and some documents (all in chinese).
could someone tell me how...
I have a project in witch i need to build a power supply witch can deliver up to 50 A and 20 volt.
Voltage adjustable from ~1.2 to ~20 VDC
Current adjustable from ~0 to ~50 A
I have built many circuits but this one is difficult. so i need your knowledge.
Please help.
thank you for your reply.
but I still dont know how to use device. I have a micro controller and like to use this device to display the temperature. can I use the adc? if yes how to calculate the temperature value.
Hi,
I have a few (KTY 10-62) temperature sensors. and I like to know to use them. I have search the net but did not find anything useful. if someone have has a link to a circuit where of which shows how to use this application.
datasheet can be found at here but its quite useless...
take a look at this sample using a atmega8 uc you can change register to atmega16
https://www.dharmanitech.com/2008/11/small-dc-motor-control-by-pwm-method.html
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.