Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
What experience do you have with LPKF Proconduct Through-Hole Plating?
I heard that there are mechanical problems if board is arched e.g. when FASTON connectors are used. Then vias loose connection.
I want to use 16-23mil (0,4-0,6mm) vias.
Is it possible to use a wave soldering with this vias...
Inductance do not depends on a type. It depends on the process how the resistance is created. If it is spiral (helix) then inductance is higher than it is cuted as meander.
Pulse robustness depends on maximal voltage of the resitors. On the other hand I have better experience with metal...
220vac voltage divider
also:
elector 2004/12 with IRF730
elector 2005/7-8 page 77 IRF730 (current source with zener diode)
Radio 1999/11 parallel stabiliser with capacitor 5-46V (2 transistors
pool
Re: voic over ip chips ?
Easier start is with Centrality PA1688
Nearly all source is available.
Cheap solution
Many designs is also on PSB21553 from infineon
Pool_77
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.