Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I have a few short pulses that trigger the transducer of an Ultrasound system. frequency id 3.5 MHz. There are about 3 to 4 pulses at 3.5 MHz. How can I use these pulses to generate a continuous train of pulses that resembles the orignal pulses?
I have a US machine that I would like too modify to make Doppler measurements too. Any thoughts? Ideas?
Also I know you need to mix the recived signal with a reference version of the transmitted signal to get the doppler frequency shift. How do I generate this reference signal?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
