Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Recent content by pk2010

  1. P

    GPS LNA Input matching Problem

    No they have not suggested any particular antenna. But of course they have mentioned at several places in datasheet. "input matched to 50 ohm using a high quality‐factor 9.1nH inductor." My antenna is 50ohm that i am sure about. And this is a general purpose gps lna so ofcourse it is ezpected...
  2. P

    GPS LNA Input matching Problem

    I am trying to match this GPS LNA with a 50hm antenna. LNA Datasheet: https://datasheet.lcsc.com/szlcsc/1912111437_AWINIC-Shanghai-Awinic-Tech-AW5005DNRZ_C401025.pdf Datasheet says that all we need is an inductor around 9.1nH to match it to 50ohm source.But practically when i measure input...
  3. P

    GPS matching network confusion

    I have to make a simple GPS Receiver board. So i have a Passive Patch->T Matching Network(Values not decided, antenna manufacturer will give me the values once they have my PCB) ->9.2nH(as specified in LNA datasheet) -> LNA -> SAW Filter -> GPSIC Patch antenna manufacturer has given me a...
  4. P

    Clean power supply for RTC

    I made a device which uses 18650 battery for runing RTC. A coin battery was not possible because the customer did not want the hassle of changing batteries for at least 3-4 years. The 12v is converted to 4.2v (because there are some other things on board which run @4.2v) I connected the VBAT...
  5. P

    Why an input inductor required in all GPS LNA?

    Hi, In almost all the datasheet of GPS LNA i have read so far, all of them say following "Output is matched to 50ohm, Input just needs a matching inductor". They even write it highlight this in the features of chip on front page that it just needs one inductor for matching. They also specify...
  6. P

    voice communication between microcontrollers

    i need to design two microcontroller based devices, both should have microphone and speaker and ethernet port.these devices should obtain a fixed ip address say 192.168.1.1 and 192.168.1.2 when connecting through a lan cable, they should be able to act as a simple phone. I don't know where to...

Part and Inventory Search

Back
Top