Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I understand that I should increase step size for frequency sweep. I will try on it, thank you. It is uncertain that some values of a parameter give me good results without error but some of them also give errors like w70 = 0.1mm is well about convergence but 0.12mm is not.
When I simulate my patch antenna design I get a error like "fast sweep setup process hf3d poor convergence in computing port dispersion"
How can i get correct results for my simulation? I want to design an array antenna(1x4) for 5G as my graduate project. You can give me also recommendations...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
