Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thank you irnenginer for your help. I have do it before you send me the message and it works. my problem for this design is the excitation. in CST, we have the application select point, edge or face, we select a point on the center of the line and the opposite point on the GND, then we select...
Thank you very much for all these informations. sorry there is one question about the rotation. for your example the Axis of rotation is Z. can I change it to Y one because in my design, I must rotate the local coordiante about Y axis and design the Dielectric Resonator following the Z axis. I...
Hi
Thank you for message and for bend the MS on the Substrat, it works great. But for the rotation of the local coordinate, I haven't foud where can I enter the angle of rotation. so please, can you tell me how can I parametrize my local coordiante.
Thanks again for your help
Hello
I'm new user of HFSS and I want to design a conformal antenna. my design consist to drow a cylinder wich composed of GND of outer raduis R and inner radius R-0.0001 then I drow another cylinder of outer raduis R-0.001 and inner radius R-0.0001-H where H is the heigh of the substrat. the...
Hello
I'm new user of HFSS and I want to design a conformal antenna. when I drow a cylinder, it appear not parfect circle but like a segmentation as show in picture attached. So please can you tell me how can I increase the shape accuracy of the cylinder to have a parfect circle???????????
Hi every body
I work in conception of Four (04) Dielectric resonator antenna array and to excite theme, I need to cut the micristrip line in Two to have the T jonction. my problem is in the matched line because in my knowledge, when the line is divised, the outer impedence is 2x the inter ones...
Need Help
Hello
I'm student in master program and I work on the conception of antennas with the CST microwave studio. I have a conception to do that I will have a Dielectric Resonator (DR) mounted on cylindrical surface. the problem is to have the above surface of the DR have the same...
hello
I want to know how can I simulate excitaion by probe-feed for conformal DR mounted on cylindric surface using CST logiciel.
thank you for your answer
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.