Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
8 volt 5 volt conversion
the power supply 24V is not my wish... its a standard power supply used in a system where i have to use this pcb....so its the only option...
power supply 24v to 5v
I would like to thank all for their replies. I tested with 7805 and its working.
Added after 4 minutes:
My one more question is...
I would like to design a pcb with atmega8 controller. So to program this controller I need to have some interface between controller and...
atmega8
hey guys,
thankyou for the response. By the way I got the requires frquency PWM this is how I made it:
#include <avr/io.h>
int main()
{
//Set up the PWM signal (page 118-119, ATmega8(L))
//The PWM signal is triggered when Timer/Counter register = Output Compare...
pwm atmega
Hello nandhu015,
thankyou for the reply. But the thing is i need 1MHz as output frequency. I am not able to generate it. If you can help me it will be greatfull.
Hello,
I would like to connect 2 analog signals of 0-10V to microcontroller MSP430F2013. So can anyone help me in the circuit diagram.
Thanking you in advance.
Hello FvM,
yes you are correct, I am looking for low level indicator but it should be small in size and less in price because i need to mount this on 250ml oil tank.
tank level sensor low cost
Hello guys,
thanks for the reply. I am looking for a sensor which can be mounted on bottom of the 250ml bottle. The bottle contains Oil. The sensor has to give signal when the liquid level is low. This bottle bottom side is mounted on another surface so i need a...
cheap liquid sensors
Hi
I am looking for a sensor which can measure low level of liquid in 250 ml tank and send signal to controller. which has to be cheap and small in size.
Hi guys....
Thanks for your replies. The problem is not only the µcontroller but how to interface the inputs and outputs to the µcontroller, because I have to make a PCB. Like the connection of 2 analog input signals to µcontroller. Do I need any regulators or any converters between...
Thankyou for the reply....
The circuit functionalities:
- Circuit will get the 2 analog signals and input power 24V. Depending on these signals the controller has to give signal to the pump. Its a piezoelectric pump.
- A signal from sensor is sent to the circuit board. It indicates low level...
Hello guys,
I am working on a project where I have to design a PCB. what I know is only the inputs and outputs and function of this board. so what I want is according to these I/O's what are all included in a PCB.
Inputs:
1) Analog signal 0-10V Speed
2) Analog signal 0-10V temperature
3)...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
