Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
No..you are not misunderstanding anything. Only thing is that I want to use a 5V relay. So I will have to step down power somehow..so the relay can take it?
Thank you.
Thank you Kak111. So, for the 2nd circuit diagram, I should use the same battery charger circuit that I have and then use two relays..Right?
Thanks once again!
Hi everyone,
I need help with this battery backup. I am using a DPDT relay here to detect the on-off of power supply. When there is power, the LM340 steps down the voltage to 5V and the battery is getting charged. I am using 4X 1.2 V NiMH battery (2600mAH) cells. I want the output to be always...
Hi everyone,
I need help with this battery backup. I am using a DPDT relay here to detect the on-off of power supply. When there is power, the LM340 steps down the voltage to 5V and the battery is getting charged. I am using 4X 1.2 V NiMH battery (2600mAH) cells. I want the output to be always...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.