Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I just wanted to post an update on these cables that I bought from Digikey....they are a bit shorter than I expected...they are NOT the exact length of the white ribbon cables in my chassis...luckily there is one ribbon cable that does not need to be as long as the others, and one of the...
You guys realize that the ribbon cable I was talking about is 20mm wide with 40 pins fit in there? That means from center to center of each pin(wire) is .5mm I would like to see an example of such soldering...cause I don't think it can be done by just anyone...
You really think that making a home-made ribbon cable is feasible? If im going that route I could just repair the cable I broke...only two of the lines in this ribbon cable were cut...is there a way to splice this back together so that I do not have to stress about this anymore? Also can you...
I was repairing my tv and I accidentally ripped a ribbon cable...on it says SUMITOMO-M AWM 2896 80C VW-1 -F- It is white with 40 pins and is about 20mm wide and 120mm long...It came from a Mitsubishi WD-52525 DLP Tv...does anyone know where I can buy one of these cables?
I checked e-bay and...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
