Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Okay, I'll try the TP4056 module, voltage booster, and which of these two modules (1 or 2) do you think I should use? (*1 has + 5V and GND pin).
EDIT: Or maybe I can remove the microUSB connector and connect the battery in the coil module?
Thank so much for your help
Thanks for your reply. Sorry if the questions are very basic, I'm a newbie to electronics (:
If I understood correctly, I have to use the Aliexpres module, a voltage booster and a TP4056 module?
I have found this voltage booster, do you know if it is good? I need it to be as thin as possible...
The coil would be used as a transmitter. Basically I want that when I plug the circuit with a mobile charger, the battery is charged, and then use that energy through the coil as a wireless charger.
From what I have read, this model in Aliexpres has these specifications:
1. Input voltage: DC...
Hi, I want to make a wireless power bank. I have thought of using a LIPO battery, TP4056 Protected Lithium Battery Charger Module and Wireless Charging Coil.
TP4056 :
Wireless Charging Coil:
Should It work?
Hello good,
First of all, thank you very much for your help.
I have updated the scheme with all the resistors, regulator and USB, I leave you the link to see if you can confirm that everything is correct.
https://easyeda.com/editor#id=%7Cb135b577d2c24b52a16c00e6fe30ee29
I wanted to ask you...
Hi, I have already configured the 5V input with micro USB and regulator to 3.3V.
Now I don't know what high level or low level means. On which pins and how do I put the resistors in the GPIOs that I use in sensors?
Thank you very much, I leave the link so you can check it...
Good evening, I am doing a project in which I want to measure air quality. I started the project with the ESP8266 NodeMcu board and three sensors, temperature (DHT22), VOC's (CCS811) and PM (PPD42).
I have it all assembled with a breadboard and the NodeMcu and it works fine.
The fact is that I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
