Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I have the same problem with xc3s400 and xcf04s (after successfully erasing,programming and verifying the PROM the loading of FPGA with Prom don't complete and the DONE pin stay in low). Could you solve the problem ? please help me.
Hi
I have made a pcb board of the attached schematic, but I it has a problem. When I
program the FPGA (xc3s400) solely through jtag (Platform cable usb II) the FPGA is program and okay, also when I
program the FLASH (xcf04s) solely it is programmed as well (as impact says), but the problem is...
Hi, I need some informationn and tutorials on the following subjects. I would be so thankful if somebidy help me with some clear and good stuffs.
1-Affine Projection Algorithm (APA)
2-equivalent Averged System
Hi ,
1-i have the zeroes and poles of a model , how can i calculate the impulse response or transfer function ?
2- i have a vector of inputs and a vector of outputs of a system in time domain . i want to calculate the impluse response (or transfer function) of this system to get the outputs of...
what is protected type ?
Hi , when i declare a shared variable like this :
shared variable o1 : bit :='0';
the warning says : the shared variable mut be of a protected type ?
what is protected type and what shall i di ?
need exemplar library
Hi , I need exemplar library (exemplar_1164) , i did a search but i couldnt find it .
i would be so thankfull if any body could give it . i am in need]
regards
(omidsht AT yahoo DOT com)
Hi , I have installed ISE10.1 and I have MATLAB R2008a.
then when I run SELECT MATLAB vesion for Sytem Generator from ise10.1 - dsp tools from start menu , in the apeared window i see my matlab , then when i tick it and select okay , it says :
"error - XILINX environment variable is not set " ...
I know that processes are in parallel .
what i mean is this :
imagine we have only one process, which there ar some sequential instructions and we have a function too.
I want to know how much time does it take to execute this process from beginning to end , and also how much time does it take...
Dear LunaCity ,
I want to do the same work as you , but my problem is that I dont know hot to program the CPLD and how to change the registers in CPLD to connect the mcbsp to expansions , please tell me how you did that , then i will try and i am sure i can solve your problem because I know...
Hi Dear Farhad , I synthezied my vhdl code with ISE9.2 and I created a
post-synthesis simulation model (or PAR). then when i want to simualte that
post-synthesis model (or PAR) , after some time ellapsed in simulation (very short
, about 20000 ns) it gets the following error and simulation...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
