Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I am using the cc1000pp module interfaced to a PIC18 series. I can read and write all registers successfully. The problem I am facing is that the clock is always running in both RX_MODE and TX_MODE hence I am getting in junk data through my DIO pin.
I am using Manchester encoded mode...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
