Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
My dead welder has mosfets labeled as TOSHIBA K2837. After an extensive 3 week search, I found data sheets with conflicting information. Until today, I could not know which ones were accurate. Now, I know why no one was able to offer help. Several sheets showed K2837 with exact specs to the...
My Chinese made (SUPER-200P model) welder’s field tube inverter board got fried. I need help identifying a replacement for it. Problem is that the welder has no schematic and it is analog and older. Also, the transformer on it is labeled as Ei28 15:7, and all other replacement boards now have...
For a multiprocess welder, I cannot find compatible replacement mosfet and their resistor parts. Of the (12) twelve K2837 mosfets and the (12) twelve 1.9 ohm 1/4W +/-0.25 tolerance resistors across them, the board fried 2 mosfets and the 2 resistors across them. Two problems… Can anyone please...
I have a project. I am a NOVICE. I would really appreciate obtaining guidance. The following is where I am with my project. I was given a multiprocess welder. It has a fried Upper Power Board. There are (2) two fried mosfets with part number K2837. There are also (2) two fried resistors. The...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.