Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi,
I have to design a solenoid driving circuit using PWM output from a controller.
Details as follows:
300hz at 1.05A
resistance: 5.3±0.3Ω
inductance8.8 to 13mH
1Vrms,series mode.
Please give me some idea in how to design....
Do we have to go for buck-boost topology?
Ha s anyone done using...
mpc5668
Hi,
Anyone is having any idea about MPC5668 processor?
Please send me the datasheet if any one gets it.....
I couldn't find frm freescale site...:(
4426 mosfet
How a n channel mosfet can be used as a switch in power line?
I want a transistor to be used to drive the mosfet.
Please help me with the schematics.
Mainly the mosfet is used to switch off the dc motor driver ic in my project
lin conformance test
Is anyone having LIN Conformance tests? Or can anyone please download it for me?
https://www.sae.org/technical/standards/J2602/2_200509
pspice dc motor model download
Hi,
Thanks for the effort. But could you please tell me how to develop a pspice model out of these laplace equations? I didn't understand much after going through the pdfs.
We want a pspice model for brushed dc motor(permanent magnet type) of torque of 50Nm...
pspice, dc motor model
Can anyone please give me a .lib file or .txt file for dc motor(pspice model)?
Pspice is already having a dc motor in pspice library. But it is having an extra pin other than + and -
What should we do with the third pin?
Has anyone used it before.Please help me at the...
Re: Patent downloading
Thanks.
Please download the following links too for me..
**broken link removed**
https://ieeexplore.ieee.org/xpl/freeabs_all.jsp?arnumber=4015140
Hi,
can anyone suggest me how to design a band stop filter (passive)for frequency between 75khz and 120 khz. having attenuation of 60db.
I m very new to filter design.
Please help
thanks,
navya
Hi,
can anyone plz tell which transistor to choose and how to design stepper motor driver circuit.
stepper motor features as follows.
Type- Unipolar
Dc coil resistance -30 ohms and above
circuit works at- 8-18V dc
driver ckt should have max current of 600 mA.
Please help.
Thanks in advance...
Re: Stepper motor doubt
Hi Frank,
Thanks a lot for your help.
One last question.
Can this controller MM908E626(stepper motor driver with hbridge inbuilt) drive this unipolar motor ?
can the vsup of the microcontroller be directly given to the stepper motor supply?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
