Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
The basic question was asking for a recommendation for the type of core material to be used for the coil construction. It was essentially answered in the 6th post by another member. I did not mean for this to continue on but I got a kind of nasty response at one point and I unfortunatly took the...
Yes, it is a unique Wind Turbine Design, based on some particular aspects of aviation/gas flow physics. But in addition, the generator is very non-standard also and has the potential for higher velocities (and heat) than a standard generator. It's also built directly into and and an integral...
Well, you did offend me!
You are making a massive amount of assumptions about me as well as everyone else on this message board.
1. The name of this particular section of the boards is titled "Elementary Electronic Questions", not "I have a PhD and 20 years experience".
2. I don't...
I'm actually working on a very different kind of generator/turbine system. It's been developed over the last 6+ years in my spare time.
I've done a ton of alternative energy research and patent searching and I believe I have a pretty unique design that will be quite a bit more efficient than a...
It seems I will need to hire someone with the knowledge to help me develop the final product. At this point I'm only doing a small proof of concept prototype so just getting some positive numbers out of the machine, even without an optimized design, may be sufficient. Thank you all for your...
I apologize for the lack of clarity in my question.
What I'm trying to ask is if anyone can provide some guidance on what core material would be most appropriate in the coil design for a Permanent Magnet Direct Current Generator design for a wind turbine. I know there are a variety of options...
Hi all.
My name is Jim Wilson and I'm working on a wind turbine design that I'm hoping to prototype, test and develop.
I'm a complete newby to electronics design, but I have over 35 years of Civil Engineering Design experience.
I need to design and have someone build a set of 20 or so...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
