Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by nagaraju.raju

  1. N

    Nets Colouring in Cadsoft Eagle 6.4

    1.> I need to color the Nets like GND, Power Supply like 3V, 5V, 12V. is it possible to do it in Cad soft Eagle 6.4. Could you please suggest your views on this, please suggest alternatives as well 2.> How to Set Differential Pairs, Length Matching traces in Eagle.
  2. N

    Altium 3D View is Not working in the System

    Hi, Iam using Aspire 4720Z laptop, i think built in Graphics card will in the Lap, could you please help me how to resolve this problem.
  3. N

    Connector Part number is required

    I need to know abt this connector, this connector Part number also i need. This Connector is using in I2C section, please find attached image for understood. Please help to what kind of connector it is?
  4. N

    Altium 3D View is Not working in the System

    Thank you so much for your response, the same Board is working in other system, i think i don't have graphics card, is there any alternative method viewing the 3D View.
  5. N

    Altium 3D View is Not working in the System

    I have problem with viewing the 3d View of the Board, the Same file other system can view the 3d View of the PCB, Even i enabled the "Show Simple 3D Bodies" please find attached board difference, could you please let me know how to resolve this.
  6. N

    How to identify if internal layers of PCB are plane layers or signal layers?

    I have a Physical board, i need to prepare schematic & layout file for physical board, the board has 4 layers (Top & Bottom, 2 Internal Plane layers). Please suggest how to identify internal layers are plane layers or Signal layers. Please suggest steps. Please find below steps has i followed...
  7. N

    IPC221A PCB Design Standarad

    I need IPC221A PCB design Standard Book, Can any one have please send. if any one have PCB Design Basics books, please send.
  8. N

    How to Group Components in PAD9.000

    Iam doing a 8-Channel Gas Analyzer Board, Each channel having same component placement, I want group Each channel, how do I group without manual placement in Pads9.0.
  9. N

    PCAD Files to Orcad Convertor

    I have some Questions on PCB & Schematic Files 1.>I Need PCad files to Orcad Convertor, Can any one tell me how to do that. Presently i have Pcad Files only, i dont have Pcad Software. 2.>Can any one Explian BGA Routing Techniques(BGA Section Divide, How to route). 3.>If any one having...
See more

Part and Inventory Search

Back
Top