Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
In a typical LoRaWAN network, range depends on numerous factors—indoor/outdoor gateways, payload of the message, antenna used, etc. On average, in an urban environment with an outdoor gateway, you can expect up to 2- to 3-km-wide coverage, while in the rural areas it can reach beyond 5 to 7 km...
Thank you vfone. Do you know how to simulate diode in CST? Problem is I have 2 spice files - for diode and for package, how to make one file from that?
Thank you very much.
Hello,
I would like to design rat-race mixer with 2 diodes. There is a lot of materials, but I didn't read any stuff around matching diodes.
Is it needed or not? I saw both types - 1, diode is on rat race without any microstripe line 2, diode is shifted from rat-race with some matching.
Does...
Hello guys,
please have somebody experience with transmitting FSK signal from SDR (in best case Adalm-Pluto)?
I would like to transmitt 2 frequencies with constant time shifting.
Thank you for reply. This is very helpful experience. Could you recommend me some book where is oscillator designed by step by step?
Thank you vfone and wish you merry christmas and happy new year.
I would like to use biasing with 4 resistors (1 for C, 2 for B, and 1 for E,see atttached file).
**broken link removed**
Well, I will focuse on BFU760 as you said vfone. Do you think that is possible to make this output power from this low current consumption - this point is critical for me...
Hello,
I would like to design oscillator for 5.8GHz. It has to be with current consumption <5mA with 5V or 3,3V it doesn't matter. Phase noise should be as low as possible. Output power has to be over 3dBm. And of course price as low as possible.
I would like to use coaxial dielectric...
Hello,
I am beginner at designing antennas and I have problem with impedance. I have coplanar waveguide in CST MWS, with width 1.275mm, gap 0.3, thickness of substrate 0.762 RO4350B, it giving me 50 ohms impedance.. and if I want to put into this waveguide nail antenna (17mm x 1.2 mm), must I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.