Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi Amit
Can you please elaborate how Unreachable points problem is solved?
sometimes Extra/Unreachable points need to be taken care since these points may also contribute to Non-eq points.
Regards,
Moorthy.S
Vids31,
The main reason was, in Pre-layout you are using wire-load models,which contains approximate delays.
Whereas in Post-layout, actual delays from SPEF. This makes the difference.
Hope this answer your queries.
Regards,
Moorthy.S
Re: setup and hold time calculation
refer the book title"static timing analysis for nanometer design:A practical approach " by J.Bhasker,Rakesh chadha.
hi
i am doing project on "TIMING CONVERGENCE".. i need the materials regarding timing convergence.. please share with me..
thanks in advance..
regards
moorthy
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.