Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thanks for your reply.
I want to do the transient simulation with sweeping the variable in each monte analysis sample, I don't want to depart the transient and sweeping simulation.
So how should I do ? Would you pls tell me in detail on how to stucture it using .alter option?
Thank you.
Hi all
I have some question about hspice simulation.
I try to do a transient simulation with sweeping a variable as the sentence below:
.tran 0.1n 100n sweep vin 1 5 0.5
The question is that I also want to do the monte carlo analysis simultaneously, so how to stucture the
netlist when I need...
Hi all,
I don't know how to define the resolution of a Latch. Dose it define from Vswing/A, A is the latch dc gain or some way else?
Thanks very much:D
latching comparator
Thank you very much for your kind suggestions
But is there anyway to add hysteresis to the latch stage, for example the latch in the figure below?
I'm going to design a Power management system, but I have no idea about it yet. Could anyone recomment some foundamental and classic books to read? Thanks a lot.
I think it is realy difficult to get a TC below 10ppm using first order compensation. First order compensation has a theoratical limit and the commonly value is 10~20ppm if well compensated. I think you can pay attention to the TC of the resistor in your circuit, maybe helpful.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
