Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I'm planning to drive 12 V DC brush motor (30W) using L6203 H-bridge driver. Most probably I will use 20 kHz locked antiphase mode. In order to avoid transient voltages in the manual of L6203 it is recommended to use snubber RC network in parallel with motor and optionally to add fast clamp...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
